• The froth pump selection will depend on the froth volume factor (FVF) and the flow rate of the slurry you need to pump.
• It need to take into consideration the throughput of the plant and the actual stream the pump is in - concentrate or tailings - as well as what section of the flotation process the pump is installed in.

• To determine the froth volume factor (FVF), you will need to take slurry samples from the suction piping, as close to the pump inlet as possible. Fill several beakers so that the results can be averaged and measure the froth column and liquid. Let it de-aerate for 24 hours and then measure again.
• The FVF is the ratio of the aerated volume to de-aerated volume. 

Froth contains very fine particles, and rubber liners withstand this type of wear very well, proving to be very cost-effective. We use rubber or metal liners, offering them in natural rubber, synthetic rubber options for slurries with hydrocarbon or reagents content, or high chrome white iron if required.

• Mineral froth is a three-phase aerated mixture containing solids, liquid and air. The air contained in the mineral froth complicates suction conditions, often resulting in an air lock at the impeller eye.
• Unlike standard centrifugal slurry pumps, AlphaFlo® horizontal froth pumps contain a unique impeller with oversized inducer blades on each vane and a large eye. This makes the entrained air bubbles dissipate or reduce in size so that they do not inhibit the flow of the slurry.

AlphaFlo® FH series slurry parts compatible with the Warman AHF slurry pumps have been rigorously reverse engineered using  2D 3D modeling. First article inspection involves comparison to OEM parts followed by fit testing. All impellers have been performance tested to certify them against OEM performance.